ZF 4699.298.014 INPUT | OEM Genuine Part

Overview

The ZF 4699.298.014 INPUT is a critical OEM genuine component engineered for the high-torque input stage of heavy-duty construction machinery transmissions. This part serves as the primary power transfer interface, receiving rotational force directly from the engine flywheel and directing it into the transmission’s planetary gear sets. Designed to withstand extreme axial and radial loads, the SKU 4699.298.014 ensures precise alignment and minimal energy loss during operation. It is typically housed within the main transmission casing and interfaces directly with the 4699101070: HOUSING and the 4699301146: HOUSING to form a sealed, lubricated assembly. This genuine ZF part guarantees factory-specified tolerances for optimal clutch pack engagement and hydraulic pressure distribution.

Symptoms of Failure

• Transmission slipping under load: A worn 4699.298.014 INPUT can cause intermittent power loss, especially when climbing grades or moving heavy materials. Operators may notice the engine revving without proportional vehicle movement.
• Metallic grinding or whining noise: Deteriorated input shaft splines or bearing surfaces produce audible high-pitched sounds from the bell housing area during gear engagement or deceleration.
• Oil leaks at the front seal interface: Excessive wear on the input component compromises the sealing surface, leading to visible transmission fluid drips near the flywheel housing. This often requires simultaneous replacement of the 0634801038: SEALING RING.
• Vibration during idle or low-speed operation: A damaged input assembly creates imbalance, transmitting harmonic vibrations through the chassis that worsen as the transmission warms up.

Technical Specifications

Compatibility

This genuine ZF input component is engineered for the WG series of powershift transmissions commonly found in wheel loaders, graders, and material handlers. It is directly compatible with the WG180 and WG200 transmission models, as well as the WG210 variant used in larger construction equipment. The part also fits select Ergopower and Ecomat series where the input housing configuration matches. For proper installation, always pair this input with a new 0636101411: CAP SCREW set and verify the 4699309085: HOUSING COVER is free from cracks. The 0631302212: CYLINDRICAL PIN must also be inspected for wear during reassembly.

Related Components